Fremont Dresser DIY Instructions

Step 1: Place boards S and S1 next to each other. Insert the right and left drawer slide into S and S1 respectively. Use tool 221 to safely hammer the left and right slides into the boards.
* Do this to all three drawer pieces.
* Make sure the prongs are on the inside.

IMG_0466

Step 2: Insert the plastic dowel 5mm into the middle hole on R.
*Do this to all three drawer pieces.

IMG_0475

Step 3: Insert the fixing brackets to S and S1.
*Do this to all three drawer pieces.

IMG_0471IMG_0472

Step 4: Insert S and S1 onto R with the slides on the outside. Make sure all the grooves line up.
*Do this to all three drawer pieces.

IMG_0478

Step 5: Then take the 13mm Euro Screws and screw them through the fixing brackets.
*Do this to all three drawer pieces.

IMG_0479

Step 6: Slide board U into the grooves of S,S1, and R.
*Do this to all three drawer pieces.

IMG_0484

Step 7: Take board T and insert the plastic dowels.
*Do this to all three drawer pieces.

IMG_0480

Step 8: Insert T in between S and S1 then screw in the 29mm flat head screw,
*Do this to all three drawer pieces.

IMG_0481

Step 9: Align U with T. Nail U to T with the crenelated nails (6). Then screw the ½” flat head screw through the left and right slide into S and S1.
*Do this to all three drawer pieces.

IMG_0485IMG_0486

Step 10: Screw the handles to R with the 5/8” screw.
*Do this to all three drawer pieces.

IMG_0489 IMG_0490

You have completed the drawers, set them aside and continue to build the dresser.

 

Step 1: Take boards C and C1 and insert the drawer slides. Use tool 221 to safely hammer the slides. Then screw the 10 mm Euro screw into the slides.

IMG_0495

Step 2: Then fasten the rubber circles onto the higher notches of the slides.

IMG_0499IMG_0502

Step 4: Insert the 15 x 12 mm Cam Klixes into C, C1, N, and N1.

IMG_0510

Step 5: Insert the plastic dowel 5mm into N and N1

Step 6: Insert N and N1 into C1. Tighten the 15 x 12 mm Cam Klixes a little more than half a turn to lock the pieces together.

Step 7: Insert C onto N and N1. Tighten the 15 x 12 mm Cam Klixes a little more than half a turn to lock the pieces together.

Step 8: Insert A onto C and C1. Tighten the 15 x 12 mm Cam Klixes a little more than half a turn to lock the pieces together.

.IMG_0520

Step 9: Nail F onto the piece.

IMG_0523

.

Step 10: Take the hinges and align them 4 inches from the edge, use a marker to mark the holes to drill.

IMG_0527

 

.

Step 11: Remove hinges and proceed to drill starter holes.
*Use a 1/16 drill bit.

Step 12: Start screwing the hinges into place.

IMG_0531

 

.

You have successfully completed your own Hidden Dresser!

hidden dresser

 

.